Mitutoyo SJ-301 - Deleting Unnecessary Data

5 - 68 No. 99MBB091A
5.13 Deleting Unnecessary Data
The SJ-301 is capable of deleting unnecessary data and performing recalculation for the
reason of outlier removal, etc.
IMPORTANT If unnecessary data is deleted, the calculation result is not correct because it is not
obtained from continuous data. In this case, “Åô” is appended to the displayed
calculation result.
NOTE For information about recalculation after deletion of unnecessary data, refer to “6.
RECALCULATION WITH THE MODIFIED MEASUREMENT CONDITIONS”.
■ Transition of screens if recalculation is performed after deletion of unnecessary data
Home screen
Measurement Condition
Setup screen (1/3)
Measurement Condition
Setup screen (2/3)
Measurement Condition
Setup screen (3/3)
Data Deletion Setup window
*1
[Page1/3]
[ON]
[Page2/3]
[RE-CAL]
[RE-CAL]
[RE-CAL]
[Condition]
[Enter] [Enter]
[Data
deletion]
Measured Profile Display
screen
Data Deletion screen
*1 After the Measured Profile Display screen is displayed, the Data Deletion screen will appear automatically.
P1 P2
P1=0.61(1220) P2=2.56(5120)
[Page2/3]
[Page3/3]
Condition JIS1994 GAUSS
c 0.8mm 5
(AUTO)
RANGE
Ra
Ry
CAL.
* * * *
* * * *
2004-05-13
 m
 m
CARD
F1 F2 F3 F4
0.5mm/s
ON
Page2/3
GO/NG
mm/inch
CUST.
mm
RANGE AUTO,ESC
RE-CAL.
Condition menu
Condition menu
RE-CAL.
ALL
STAND
Page3/3
DRIVE
OFF
N5
Condition menu
STAND.
PROFILE
FILTER
c
s
EVA-L
RE-CAL.
JIS'94
R
GAUSS
4.0mm
0.8mm
2.5m
Page1/3
Condition menu
RE-CAL.
ALL
STAND
Page3/3
DRIVE
OFF
ON
OFF