8 - 15
No. 99MBB091A
8. SAVE/READ OF MEASUREMENTS, MEASUREMENT CONDITIONS AND STATISTICAL DATA
8.2.2 Recalling the measurement conditions
Measurement conditions saved in the internal memory or memory card (optional) can be read
as necessary.
To read the measurement conditions first bring up the Measurement Condition Recall screen
from the Measurement Condition Setup screen, then select the media (internal memory or
memory card). Subsequently, perform appropriate operations such as file selection.
TIP In addition to the Measurement Condition Setup screen, the [CONDITION READ]
key on the Display Unit can be used to recall measurement conditions from internal
memory. For more information refer to “■ How to read measurement conditions with
the [CONDITION READ] key”, which appears later in this manual.
Whether the internal memory or a memory card is being used as the storage media, the recall
screens are virtually identical. However, the screen for specifying a source recall file and the
operations involved will differ.
The following example uses screens that read the measurement conditions from internal
memory.
IMPORTANT Multiple files stored cannot be recalled at the same time.
NOTE When the stored measurement conditions are read, the following conditions will also
be read to replace the existing SJ-301 settings at the same time:
Print conditions, DATA key function setup, and calibration conditions.
To Next Page
Loading...
