Mitutoyo SJ-301 - Home Screen of the Touch Panel

No. 99MBB091A 2 - 10
2.3 Home Screen of the Touch Panel
When the power to the SJ-301 is turned on, the Home screen is displayed in the touch panel.
The function of each button and icon displayed on the Home screen is explained here.
■ Function of the Home screen
Condition JIS1994 GAUSS
c 0.8mm 5
(AUTO)
RANGE
Ra
Ry
CAL.
1.54
7.41
2000-01-01
 m
 m
CARD
F1 F2 F3 F4
The parameter values
are displayed.
Touch this button to move to the Measurement Condition Setup screen.
Touch this button
to move to the
Calibration screen.
Touch this button to move
to the Data Save/Call screen.
Touch this button to display
the measured profile.
Touch either button to change the parameter display.
Touch this button to move
to the 2nd Home screen
Indicate
the stylus position.
■ Function of the 2nd Home screen
If the
F1 F2 F3 F4
(SHIFT) button in the Home screen is touched, a modified screen called
2nd Home screen appears where the button configuration is as shown in the figure below.
F1 F2 F3 F4
Condition JIS1994 GAUSS
c 0.8mm 5
(AUTO)
RANGE
Ra
Ry
1.54
7.41
2000-01-01
 m
 m
STAT. I/O
Touch this button to move
to the Home-Screen.
Touch this button to move to the Measurement Condition Setup screen.
Touch this button to move
to the Statistical Condition Setup screen.
Touch either button to change
the parameter display.
Touch this button to move to the
I/O Condition Setup screen.
Indicate
the stylus position.