Mitutoyo SJ-301 - Page 129

5 - 31 No. 99MBB091A
5. MODIFYING THE MEASUREMENT CONDITIONS
■ Setting the pre-travel/post-travel to off.
2
<Measurement Condition Setup screen (1/3)>
4
<Pre-travel/Post-travel Setup window>
Condition JIS1994 GAUSS
c 0.8mm 5
(AUTO)
RANGE
Ra
Ry
CAL.
1.54
7.41
2000-01-01
 m
 m
CARD
1 <Home screen>
[Condition]
F1 F2 F3 F4
3
<Measurement Condition Setup screen (2/3)>
0.5mm/s
ON
Page2/3
GO/NG
mm/inch
CUST.
mm
RANGE AUTO,ESC
RE-CAL.
Condition menu
ON OFF
Setting buttons
0.5mm/s
ON
Page2/3
GO/NG
mm/inch
CUST.
mm
RANGE AUTO,ESC
RE-CAL.
Condition menu
N5
Condition menu
STAND.
PROFILE
FILTER
c
s
EVA-L
RE-CAL.
JIS'94
R
GAUSS
4.0mm
0.8mm
2.5m
Page1/3
[Pre-travel/Post-travel]
[Page 1/3]
Touch the [Condition] button in the Home screen.
The Measurement Condition Setup screen(1/3) will appear.
Touch the [Page 1/3] button in the Home screen.
The Measurement Condition Setup screen(2/3) will appear.
Touch the [Pre-travel/Post-travel] button.
The Pre-travel/Post-travel Setup window will appear.
Touch the appropriate button to make a setting.
The button touched will be highlighted.
[ON] :
Traversing length includes the pre-travel/post-travel
lengths
[OFF] :
Traversing length does not include the pre-travel/post-
travel lengths