5 - 37
No. 99MBB091A
5. MODIFYING THE MEASUREMENT CONDITIONS
4
<Parameter Select screen>
Parameter buttons
5
<Parameter Select screen>
6
<Parameter Select screen>
[Enter]
Parameter group buttons
Parameter buttons
Parameter group buttons
Select parameter
Custom
P1
Rp
Rv
P2
P3
Rz
Ra
Rq
Ry
Rt
P4
P5
RSm
ESC
R
Measured profile button
Annex A
P3
A1
A2 Vo
P1
P2
P5
Rk
Rpk
Mr1
Rvk
Mr2
P4
DIN4776
Select parameter
Custom
ESC
Annex A
DIN4776
Select parameter
Custom
ESC
P3
A1
A2 Vo
P1
P2
P5
Rk
Rpk
Mr1
Rvk
Mr2
P4
Annex A
Touch the measured profile button as required until the
desired profile appears in the button.
Each time the button is pressed, the measured profile is
switched, the parameter group button corresponding to the
profile is highlighted, and the parameter button display
will also be switched.
• Parameters can be selected for each measured profile. If a
measured profile is specified the parameters selected for
that measured profile will be recalled.
• These parameters are divided into five groups P1 through
P5.
P1: Parameters (group 1)
P2: Parameters (group 2)
P3: Parameters (group 3)
P4: DIN4776 parameters
P5: Motif parameters
TIP The screen shown in step 5 at the left is an
example of a DIN4776-profile.
Touch the button of a desired parameter
The touched parameter button will be highlighted. If it is
touched again, it will be de-highlighted.
TIP Parameter groups can be switched by touching
the parameter group buttons.
If the parameter group is switched over, the
parameters available in the selected group
will be displayed on the parameter buttons.
For more information refer to “■ The param-
eters and the measured profiles”.
If all the parameters to be set are highlighted, touch the
[Enter] button to accept the selected parameters.
The Measurement Condition Setup screen (2/3) is restored.
To Next Page
Loading...
