5 - 57
No. 99MBB091A
5. MODIFYING THE MEASUREMENT CONDITIONS
■ Operating procedure
3
<Measurement Condition Setup screen (2/3) >
4
<Parameter Select screen>
Condition
JIS1994
GAUSS
0.5mm 5
(AUTO)
RANGE
R
AR
CAL.
* * * *
* * * *
2004-05-15
m
m
CARD
2
<Measurement Condition Setup screen (1/3) >
1 <Home screen>
0.5mm/s
OFF
Page2/3
GO/NG
mm/inch
CUST.
mm
RANGE AUTO,ESC
RE-CAL.
Condition menu
s
B
EVA-L
Condition menu
Page1/3
STAND.
L
RE-CAL.
ISO'97
MOTIF.R
A
0.5mm
16.0mm 16.0mm
8m
PROFILE
FILTER
Annex A
Select parameter
Custom
Wx
Wte
P2
P3
Rx W
AW
P1 R AR
P4
ESC
MOTIF.R
P5
Touch the [Measurement Conditions] button in the Home
screen.
The Measurement Condition Setup screen (1/3) will
appear.
Touch the [Page 1/3] button.
The Measurement Condition Setup screen (2/3) will
appear.
Touch the [Customize] button.
The Parameter Select screen will appear.
Touch the [Connection Method Setup] button on the Param-
eter Setup window.
The connection method will be set.
Annex A
Annex A
: ISO 12085 Standard Annex A compatible
connection method
: ISO 12085 Standard Body compatible
connection method
NOTE If a measured profile is other than a motif, the
connection method setup will be invalidated.
To Next Page
Loading...
