Mitutoyo SJ-301 - Recalculation procedure

No. 99MBB091A 6 - 2
■ Recalculation procedure
1 <Measurement Condition Setup screen>
2 <Measurement Condition Setup screen>
<Home screen>
Condition ISO1997 2CR
c 0.8mm 3
(AUTO)
RANGE
Ra
Ry
CAL.
1.55
7.44
2000-01-01
 m
 m
CARD
F1 F2 F3 F4
Condition menu
STAND
PROFILE
FILTER
c
s
N
EVA-L
RE-CAL.
ISO'97
R
2CR
2.4mm
3
0.8mm
2.5m
Page1/2
Condition menu
STAND
PROFILE
FILTER
c
s
N
EVA-L
RE-CAL.
ISO'97
R
2CR
2.4mm
3
0.8mm
2.5m
Page1/2
0.5mm/s
ON
Page2/2
GO/NG
mm/inch
CUST.
mm
RANGE AUTO,ESC
RE-CAL.
Condition menu
[RE-CAL.]
Measurement condition modification is possible in the
Measurement Condition Setup screen after the measurement
has been completed with the measured result being displayed
on the touch panel.
TIP For information about modifying the measure-
ment conditions, refer to chapter 5, “MODIFY-
ING THE MEASUREMENT CONDITIONS”.
Touch the [RE-CAL.] button in the Measurement Condition
Setup screen after having modified the conditions.
A bar indicating the progress of recalculation will be
displayed.
After recalculation has been completed, the Home screen
is restored. The recalculated measurement data will be
displayed in the Home screen.