9 - 13
No. 99MBB091A
9. SPC OUTPUT AND DATA COMMUNICATION
■ Switching the SJ-301 to the RS-232C mode
1. Restore the Home screen.
Condition
JIS1994
GAUSS
c 0.8mm 5
(AUTO)
RANGE
Ra
Ry
CAL.
1.54
7.41
2000-01-01
m
m
CARD
F1 F2 F3 F4
2. Turn on the RS-232C switch, which is on the rear side of the Display Unit.
RS-232C switch
This brings up the RS-232C mode indicated as “REMOTE MODE” on the screen as
shown below.
2000-01-01
REMOTE MODE
NOTE It the RS-232C switch is turned on while other than the Home screen is being
displayed, the RS-232C mode will not be entered at that time of the point but will be
entered by pressing the [Home] button.
TIP For information about available commands refer to section 13.10, “RS-232C Commu-
nication Specifications”.
To Next Page
Loading...
