Mitutoyo SJ-301 - Page 259

10
10 - 1 No. 99MBB091A
INSTALLING THE SJ-301
WITH OPTIONAL
ACCESSORIES
Various optional accessories are offered for the SJ-301 so it can measure a curved (cylindri-
cal, etc.) workpiece or a workpiece with a measured surface smaller than the size of the
Drive/Detector unit of the SJ-301.
■ Support feet No. 12AAA216
Used to measure a workpiece which is smaller than the Drive/Detector unit.
● Dimensions and application example
Use the Support feet on the Drive/Detector unit to adjust it to the required height as shown
below.
8
.5 (.335")
53 (2.087")
30.5 (1.200")
Workpiece
Drive/Detector un
it
Support feet
No.12AAA216
Unit : mm (inch)