3 - 7
No. 99MBB091A
3. SETTING UP THE SJ-301
● Loading printer paper
1. To load a new roll of printer paper, remove the printer paper remaining in the SJ-301
Display unit. Pull up on the lever when taking out the paper, as shown in the figure.
IMPORTANT Do not move the blue levers. The roller is disengaged if either lever is moved.
Lever
Blue levers (Do not move.)
2. After feeding one end of the printer paper through the roller, set the paper roll in the
Display unit as shown in the figure.
Printer paper
Roller
Side view (Section view)
Printer paper
Roller
3. Reposition the lever, as shown below, after setting the printer paper.
Lever
To Next Page
Loading...
