3 - 27
No. 99MBB091A
3. SETTING UP THE SJ-301
■ Storing the Drive/Detector unit inside the Display unit
The Drive/Detector unit can be stored inside the Display unit without disconnecting the
connecting cable.
1. Open the carrying case cover.
2. Open the drive unit cover of the Display unit.
3. Pass the connecting cable through the cuts provided on both rear edges of the carrying
case.
4. Hitch the connecting cable on the cut at the front left side of the carrying case.
Cut
Carrying case cover
Cut
Cut
Connecting cable
Drive unit cover
5. Store the Drive/Detector unit inside the Display unit without disconnecting the cable.
(1)
(2)
(3)
Drive/Detector unit
Drive unit cover
Drive unit clamp lever
TIP See Chapter 11 for details of storing the Drive/Detector unit inside the Display unit.
6. The sag of the cable can be stacked in the recess between the carrying case and the
Display unit.
7. Close the drive unit cover.
8. Close the carrying case cover.
To Next Page
Loading...
