NOTICE: The MCC 7100 IP Dispatch Console supports four local Aux Outputs with specific
functions tied to them:
• Indicating Emergency;
• Indicating presence of an inbound call on the currently selected channel
• Indicating a console PTT
• Providing an external output to report activity of one or more general Aux I/Os of the
console.
If you employ the Aux I/O Server device in a Conventional Subsystem, configure it properly to support
the Unified Network Configurator (UNC) discovery. Perform the configuration using the SDM3000
Builder application. If the Aux I/O Server device used in a Conventional Subsystem is not configured
properly, UNC discovery lists the device in the UNC Lost and Found folder. If this situation occurs,
configure the device properly and rediscover it. For detailed information about the SDM3000 Builder,
see the MOSCAD Network Fault Management manual. After the UNC recognizes the Aux I/O Server
device in a Conventional Subsystem, you can use UNC to configure the device. For more information,
see the Unified Network Configurator manual.
MN000672A01-E
Chapter 1: MCC 7100 IP Dispatch Console Description
38 Send Feedback
To Next Page
Loading...
Need help?
General