• Verify that the FLEXlm License Manager service is up and running:
- If the service is not running, start the service.
- If the service is running but the motsol.exe executable is not running in the Task Manager,
restart the service.
Changing the Maximum Transmission Unit
If intermediate network elements (routers, switches) drop packets greater than 1500 bytes, it may be
necessary to change the value of the Maximum Transmission Unit (MTU) on the PRX 7000 Console
Proxy or the MCC 7100 IP Dispatch Console to a lower value.
CAUTION: Modify the MTU only as a last resort, after the all network settings have been check
and verified.
Procedure:
1 Select Start and enter regedit in the search field.
2 In the registry editor, navigate to HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet
\Services\Tcpip\Parameters\Interfaces\interface-name.
3 Right-click MTU of type REG_DWORD and select Modify.
4
Enter the desired MTU size in hexadecimal.
NOTICE: The range of the MTU is 0x44 to the dynamically determined MTU (in bytes).
Set this value to 0xFFFFFFFF, to change the MTU back to the default value of the
network interface dynamically determined MTU.
5 Click OK.
6 Close the Registry Editor.
7 Restart the computer.
PRX 7000 Console Proxy Disaster Recovery
This section provides details and references to help recover the PRX 7000 Console Proxy in the event
of a failure.
Recovering a PRX 7000 Console Proxy Installation
Use disaster recovery if the current installation of the PRX 7000 Console Proxy has become unstable
or inoperable. Follow this process to reinstall all necessary components.
Recovery of a PRX 7000 Console Proxy during a disaster recovery event requires a full installation.
Process:
1 Backup critical files used by the PRX 7000 Console Proxy. See Critical Backup Files for the PRX
7000 Console Proxy on page 100 for a list of files.
2 If necessary, install the Windows operating system. See Operating System Installation for the
PRX 7000 Console Proxy on page 90.
3 Optional: If performing disaster recovery on replacement hardware, generate new License
Certificates for the PRX 7000 Console Proxy. See Generating License Certificates for the PRX
7000 Console Proxy on page 91.
4 Install the PRX 7000 Console Proxy software. See Installing the PRX 7000 Console Proxy
Software on page 92.
5 Optional: Install MOTOPATCH. See MOTOPATCH Installation on page 61.
MN000672A01-E
Chapter 3: PRX 7000 Console Proxy Setup and Installation
Send Feedback 99
To Next Page
Loading...
Need help?
General