Motorola solutions MCC 7100 IP - Mapping and Unmapping a Non-Motorola Desktop Microphone; Ptt;Monitor Tab; Configuring a Non-Motorola USB Footswitch

Mapping and Unmapping a non-Motorola Desktop Microphone
Map or unmap microphone devices by changing the current settings in the Audio Inputs tab.
Procedure:
1 From the Windows Start menu, select All Programs → Motorola → MCC 7100 Dispatch →
Peripheral Configuration Tool.
2 Select the Audio Inputs tab.
3
Map or unmap a microphone device by performing one of the following actions:
•
To map a microphone device, from the drop-down list next to the device, select Desktop
Microphone.
• To unmap a microphone device, from the drop-down list next to the device, select the blank
selection.
NOTICE:
Only one desktop microphone can be configured for the MCC 7100 IP Dispatch Console.
If you use a non-Motorola desktop microphone and either a non-Motorola headset or the
Motorola-standard headset is mapped in the Peripheral Configuration Tool and
connected to the dispatch console, you cannot transmit by using the desktop
microphone. Use the headset microphone.
4 Close the Peripheral Configuration Tool by clicking OK.
PTT/Monitor Tab
The PTT/Monitor tab displays a list of dispatch Push To Talk (PTT) devices connected to the
computer. The tab supports USB foot switches, USB headsets with PTT functionality, and joysticks.
Configuring a non-Motorola USB Footswitch
Configure a USB footswitch as a Push-to-Talk (PTT) in the Peripheral Configuration Tool.
Prerequisites: Connect the USB footswitch to the computer and install all the necessary USB
footswitch drivers.
Procedure:
1 From the Windows Start menu, select All Programs → Motorola → MCC 7100 Dispatch →
Peripheral Configuration Tool.
2 Select the PTT/Monitor tab.
3 From the drop-down list next to the device that you want to use as the PTT device, select
Footswitch.
The footswitch icon in the Summary pane is highlighted.
4 Optional: Test the PTT device by using the test buttons in the Button Test pane.
You can use the test buttons only to test non-Motorola PTT devices. The buttons are not
available for the Motorola PTT devices connected to the USB Audio Interface Module.
5 Save the profile:
• To save the changes to the existing profile, select Apply.
• To save the changes as a new profile, select Save As.
6 Close the Peripheral Configuration Tool by clicking OK.
MN000672A01-E
Chapter 5: Console Dispatch Status and Peripheral Configuration Tool
Send Feedback 131