â–ª If your pads are in Keyboard mode, the lit pads show you the pitches (of the focused
Sound) for which the Pattern contains events.
In other terms you don’t need to press any unlit pad, since there are no events to delete there.
While holding EVENTS + ERASE you can press several pads to delete their events.
If you accidentally deleted events, press UNDO (in the EDIT section) to undo it!
Deleting the Selected Events
Once you have selected particular events (see ↑7.4.3, Selecting Events/Notes for more on
this), you can delete them from the Pattern:
â–º
Press CLEAR (in the EDIT section) to erase the selected events. If nothing is selected, all
event/notes in the Pattern will be affected.
Deleting Events while Playing
If the sequencer is currently playing, you can selectively erase events at the play position:
â–º
While the Pattern is playing, hold ERASE + the desired pad to progressively delete the
events for that Sound (if pads are in Group mode) or the notes at that pitch for the fo-
cused Sound (if pads are in Keyboard mode) as they are reached by the playhead.
→
As long as you hold the pad, the corresponding events are deleted as the playhead moves
on.
You can use this to selectively erase notes at a particular place in the Pattern.
This might take some time getting used to, especially when the tempo is very fast, but
you can always press UNDO/REDO to get back to where you were before.
Deleting Events for the Entire Group at Playback Position
Using your controller you can erase events for all Sounds in the Group at the playback position.
â–º
While the Pattern is playing, hold ERASE + the desired Group button A–H to progressive-
ly delete events for all Sounds in that Group as they are reached by the playhead.
Working with Patterns
Editing Events
MASCHINE STUDIO - Manual - 392
To Next Page
Loading...
Need help?
General
