→
The next time you select a new Section or group of Sections for looping, the switch will
happen on the next division selected here.
â–º
To enable/disable the Retrigger setting, click the little cog wheel in the MASCHINE
Header and select Retrigger from the menu.
→
The next time you select a new Section or group of Sections for looping, the new loop will
start from the beginning of the first Section (Retrigger enabled) or from the same position
as where it left the current Section (Retrigger disabled).
13.1.3.2 Jumping to Other Sections using the Controller
To adjust the Perform Sync setting:
1. Press and hold GRID to enter Grid mode (or pin it by pressing GRID + Button 1).
2. Press Button 2 to select PERFORM.
⇨ On the right display you see the available Section Sync values. The current value is high-
lighted and the corresponding pad is lit. The default value Section means that the next
time you select a new Section or loop range for playing, the switch will happen once the
current Section has played to the end.
3. Press a pad to select the desired value, for example pad 3 (for 1/4, a quarter note).
→
The next time you select a new Section or loop range, the switch will happen on the next
quarter note.
To adjust the Retrigger setting:
1. Press and hold SCENE to enter Section mode (or pin it by pressing SCENE + Button 1).
2. Press the Right Page button to access page 2.
3. At the bottom left corner of the left display you see the current RETRIGGER value (Off by
default).
4. Turn Knob 1 to select On.
The next time you select a new Section or loop range, it will start from the beginning.
Working with the Arranger
Arranger Basics
MASCHINE STUDIO - Manual - 753
To Next Page
Loading...
Need help?
General
