Parameter Description
ADJUST If BPM is set to Auto, you can choose between the tempo that
MASCHINE detected, or half or double of that tempo. If BPM is set
to Manual, you can adjust the tempo manually.
ENGINE Section (Detect mode only)
ZERO-X (Zero
Crossing, Detect mode
only)
When MODE is set to Detect, activate ZERO-X to force the detected
Slices to be created on the closest locations where the audio signal
crosses the zero value. This can be helpful to avoid clicks when
playing back Slices in another sequence.
Adjusting the Slicing Settings on the Controller
At the bottom of the left display, you can adjust the settings used to define where the various
Slices will be created in the Sample.
Adjust the slicing settings via Knob 1–4.
Any change to these settings will directly affect the number and position of the Slice markers
shown in the waveform on the displays.
Selecting and Pre-Listening the Slices with the Pads
At any time, the proposed Slices are also available on your pads: The fully lit pad indicates the
selected Slice, while the dim lit pads indicate the other Slices.
Sampling and Sample Mapping
Slicing a Sample
MASCHINE STUDIO - Manual - 843
To Next Page
Loading...
Need help?
General
