Parameter Description
AUTO-SNAP (Manual
mode only)
The Sample Slicer Manual mode Auto-Snap feature automatically
aligns Slice points to the nearest transient as you manually trigger
the slicing from the pads. It can be turned off so that slice points are
instead placed exactly where you trigger them. In order to use Auto-
Snap, you must wait for analysis to be performed on the sample
you’re slicing—the analysis is very quick but will take longer for long
audio files.
SENSITIVITY (Detect
mode only)
When MODE is set to DETECT (see above), SENSITIVITY lets you
adjust the sensitivity of the transient detection. Higher values will
cause more Slices to be detected because more transients will be
recognized, lower values will result in less Slices. This parameter
should be adjusted until all the musically significant slices are being
detected in the waveform.
BPM (BPM Mode) Selects how the tempo is defined: If you select AUTO, MASCHINE
will calculate the tempo automatically. If you select MANUAL, you
can enter the tempo in BPM manually.
ADJUST If BPM is set to AUTO, you can choose between the tempo that
MASCHINE detected, or half or double of that tempo. If BPM is set
to MANUAL, you can adjust the tempo manually.
When MODE is set to DETECT, a second section of parameters is available at the bottom of the
left display: the ENGINE section.
â–º
When MODE is set to DETECT, press the Right Page button to show the ENGINE section.
Sampling and Sample Mapping
Slicing a Sample
MASCHINE STUDIO - Manual - 845
To Next Page
Loading...
Need help?
General
