Electra Elite IPK II Document Revision 4C
Voice Response System (VRS) 2 - 1105
 You hear the previously recorded message. If you hear a beep instead, no previous message is recorded.
5. Press # to hear the message again.
- OR -
To hear another message, dial 5 and then enter the message number (01~48).
- OR -
Hang up.
To erase a previously recorded VRS message:
1. Press Speaker or lift the handset.
- OR -
At a single line telephone, lift the handset.
2. Dial 616.
3. Dial 3 (
Erase).
4. Dial the number of the VRS message you want to erase (01~48).
5. Press Hold (multiline terminal only) to cancel the procedure without erasing (and return to step 3).
- OR -
Hang up to erase the message.
To record, listen to or erase a VRS message if you call in using DISA:
1. Place call to the system.
 You hear dial tone.
2. After the system answers, dial the DISA password (normally 000000).
 You hear dial tone.
3. Dial 616 and the VRS password.
4. Dial the function you want.
7 =
Record
5 =
Listen
3 =
Erase
5. Dial the message number (01~48), record the message and press
# to end recording.
 If you dialed 7 to record, you can dial # to listen to the message you just recorded.
 If you dialed 5 to listen, you can dial 5 and the message number to hear it again or if you want to Record, listen
to or erase another message, go back to step 4.