NEC Electra Elite IPK II System - Page 161

Electra Elite IPK II Document Revision 4C
Call Forwarding, Off-Premise 2 - 137
 20-13-06 Class of Service Options (Supplementary Service) – Automatic Off-Hook Signaling
(Automatic Override)
Allow a busy extension to manually (0) or automatically (1) receive Off-Hook signals.
 24-02-07 System Options for Transfer – Trunk-to-Trunk Transfer Release Warning Tone
Timer starts when a trunk begins talking with another trunk (for example: Trunk-to-Trunk
Transfer, outgoing from trunk, Tandem Trunking) (0~64800 seconds, default: 1800). When this
time expires, a warning tone is heard.
 24-09-01
through
24-09-07 Call Forward Split Settings
Assign Call Forwarding type and the destination numbers for each extension/virtual extension.
 25-07-07 System Timers for VRS/DISA – Long Conversation Warning Tone Time
Determine the time a DISA caller or any Trunk-to-Trunk (such as Tandem Trunking)
conversation can talk before the Long Conversation tone is heard (0~64800 seconds).
(default: 3600)
 25-07-08 System Timers for VRS/DISA – Long Conversation Disconnect
Determine the time the system waits before disconnecting a DISA or any trunk-to-trunk (such as
Tandem Trunking) call after the Long Conversation tone is heard (0~64800 seconds).
(default: 10)
Trunk-to-Trunk Forwarding – Normal (0) Trunks
 11-10-06 Service Code Setup (for System Administrator) – Setting the Automatic Transfer for Each
Trunk Line
Customize the service code used to set the Automatic Trunk Forwarding feature (default: 733).
 11-10-07 Service Code Setup (for System Administrator) – Canceling the Automatic Transfer for
Each Trunk Line
Customize the service code used to cancel the Automatic Trunk Forwarding feature (default:
734).
 11-10-08 Service Code Setup (for System Administrator) – Setting the Destination for Automatic
Trunk Transfer
Customize the service code used to set the destination for the Automatic Trunk Forwarding
feature (default: 735).
 13-01-01 Speed Dialing Option Setup – Speed Dialing Auto Outgoing Call Mode
Determine if dialing a Speed Dialing number dials an outside number (seizing a trunk as
assigned in Program 13-05) or an Intercom number (0 = Trunk Dialing Mode, 1 = Extension
Dialing Mode).
 13-04-01 Speed Dialing Number and Name – Speed Dialing Data
Enter the Common and Group Speed Dialing numbers and names which are to be used for
Trunk-to-Trunk Forwarding.
 14-01-26 Basic Trunk Data Setup – Automatic Trunk-to-Trunk Transfer Mode
Enable (1)/Disable (0) trunk ability to use Step Transfer.