NEC Electra Elite IPK II System - Page 162

Document Revision 4C Electra Elite IPK II
2 - 138 Call Forwarding, Off-Premise
 20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to an extension.
 20-07-05 Class of Service Options (Administrator Level) – Automatic Trunk-to-Trunk Transfer
Enable (1)/Disable (0) an extension user ability to use the Trunk-to-Trunk Forwarding service
codes.
 22-02-01 Incoming Call Trunk Setup – Incoming Type
Assign the incoming type for each trunk. There is one item for each Mode. When using
Trunk-to-Trunk Forwarding the trunks must be set for Normal (0).
 24-02-11 System Options for Transfer – No Answer Step Transfer
Assign the time each transfer destination rings before step transfer is performed.
 24-02-12 System Options for Transfer –No Answer Trunk-to-Trunk Transfer
Define the elapsed time before the automatic Trunk-to-Trunk Transfer is performed.
 24-04-01 Automatic Trunk-to-Trunk Transfer Target Setup
Assign the Speed Dialing number bin (0~1999) to a trunk and the mode which should be used
as the destination of the Automatic Trunk-to-Trunk Forwarding.
Trunks: 001~200
Time Modes: 1~8
Trunk-to-Trunk Forwarding – DID (3) Trunk Forwarding by Department Groups

Refer to Department Calling for additional Department Group programming.
 11-07-01 Department Group Pilot Numbers – Dial
Assign pilot numbers to the Extension (Department) Groups you set up in Program 16-02.
 11-11-25 Service Code Setup (for Setup/Entry Operation) – Automatic Transfer for Each Extension
Group
Customize the service code used to set the Automatic Trunk Forwarding feature for a
Department Group (default: 602).
 11-11-26 Service Code Setup (for Setup/Entry Operation) – Automatic Transfer Cancellation for
Each Extension Group
Customize the service code used to cancel the Automatic Trunk Forwarding feature for a
Department Group (default: 603).
 11-11-27 Service Code Setup (for Setup/Entry Operation) – Destination of Automatic Transfer Each
Extension Group
Customize the service code used to set the destination for the Automatic Trunk Forwarding
feature for a Department Group (default: 604).
 13-01-01 Speed Dialing Option Setup – Speed Dialing Auto Outgoing Call Mode
Determine if dialing an Speed Dialing number dials an outside number (seizing a trunk as
assigned in PRG 13-05) or an Intercom number (0 = Trunk Dialing Mode, 1 = Extension Dialing
Mode).