Document Revision 4C Electra Elite IPK II
2 - 22 Account Code – Forced/Verified/Unverified
Station Message Detail Recording
Programming
14-01-11 Basic Trunk Data Setup – Account Code Required
Enable (1) or disable (0) Forced Account Codes for each trunk.
15-07-01 Programmable Function Keys
Assign a function key as an Account Code key (code 50). Use this key instead of the dial pad to
enter the
before and after the Account Code.
20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to an extension.
20-13-20 Class of Service Options (Supplementary Service) – Account Code/Toll Restriction
Operator Alert (Restricted Operation Transfer)
Turn Off (0) or On (1) the Operator Alert when a forced account code is incorrectly entered.
21-04-01 Toll Restriction Class for Extensions
Assign a Toll Restriction Class (1~15) to an extension.
35-05-01 Account Code Setup – Account Code Mode
For each Class of Service (1~15), select the Account Code Mode. The options are:
0 = Account Codes disabled. (Any codes you enter dial out as part of your initial call.)
1 = Account Codes optional (not required).
2 = Account Codes required (forced) but not verifiable.
3 = Account Codes required (forced) and verifiable.
35-05-02 Account Code Setup – Forced Account Code Toll Call Setup
For each Class of Service (1~15), enter 1 to enable Forced Account Codes just for toll calls.
With this option enabled, local calls have Optional Account Codes. Enter 0 to enable Forced
Account Codes for local and toll calls. If a user needs to dial
as part of post-dialing digits, the
must be pressed three times (twice for the expected account code entry and the third as the
post-dialing digit).
35-05-03 Account Code Setup – Account Codes for Incoming Calls
For each Class of Service (1~15), enter 1 to enable Account Codes for incoming calls. Enter 0 to
disable Account Codes for incoming calls. If disabled, any codes you enter dial out on the
connected trunk.
35-05-04 Account Code Setup – Hiding Account Codes
For each Class of Service (1~15), enter 1 to have the system hide Account Codes on an
extension display as they are entered. Enter 0 to have the Account Codes displayed.
35-06-01 Verified Account Code Table – Verified Account Code
Enter data in the Verified Account Code Table. You can enter up to 2000 codes with 3~16 digits.
For a wild card @, press the LK 1.
40-10-01 Voice Announcement Service Option – VRS Fixed Message
Use (1) or Don't Use (0) the Fixed VRS messages.
To Next Page
Loading...
Need help?
General
