NEC Electra Elite IPK II System - Page 806

Document Revision 4C Electra Elite IPK II
2 - 782 Park
Park key (code 07).
 15-18-01 Virtual Extension Key Enhanced Options – Virtual Extension Key Operation Mode
Set whether an incoming call to a Virtual Extension/CAR resides on the Virtual Extension/CAR
key once answered (1) or appears on a CAP Key/CO Appearance Line key (0). This setting
applies to Multiline Terminals, single line telephones and virtual extension numbers (default: 0).
 15-18-02 Virtual Extension Key Enhanced Options – Display Mode when pacing a call on Virtual
Extension Key
(default: 0)
 20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to extensions.
 20-11-19 Class of Service Options (Hold/Transfer Service) – Hold/Extended Park
Determine whether an extension Class of Service should allow normal (0) or extended Park (1).
(default: 0)
 20-11-27 Class of Service Options (Hold/Transfer Service) – Call Park Automatically Search
Enable (1)Disable (0) using the Call Park Automatically Search option.
(default: 1)
 24-01-02 System Options for Hold – Hold Recall Callback Time
A call left parked too long recalls the extension that initially parked it for this time (0~64800
seconds).
(default: 30)
 24-01-06 System Options for Hold – Park Hold Time - Normal
Set the Park Hold Time (0~64800 seconds). A call left parked longer than this time recalls the
extension that initially parked it. (default: 90)
 24-01-07 System Options for Hold – Park Hold Time - Extended (Recall)
Set the Extended Park Hold Time (0~64800 seconds). A call left parked longer than this time
recalls the extension that initially parked it. (default: 300)
 24-03-01 Park Group – Park Group Number
Assign an extension to a Park Group (01~64). An extension can only pick up a call parked by a
member of its own Park Group. (default: 1)
Operation
To Park a call in a system orbit:

You can Park Intercom or trunk calls.
1. Press the Park key (PRG 15-07 or SC 752: 04 + orbit).
 The Park key LED lights.
 If you hear busy tone, the orbit is busy. Try another orbit.
2. Use Paging to announce call.