SECTION 6
MAINTENANCE
144
ALWAYS POWER DOWN THE PRINTER BEFORE CONNECTING OR DISCONNECTING ANY
WIRING HARNESSES OR CABLE CONNECTIONS TO AVOID SERIOUS SHOCK OR INJURY.
ALWAYS USE APPROPRIATE PERSONAL PROTECTION EQUIPMENT (PPE).
USE ELECTROSTATIC DISCHARGE (ESD) PROTECTION WHEN MAINTAINING EQUIPMENT.
DISPOSE OF ALL MAINTENANCE WASTE IN ACCORDANCE WITH LOCAL REGULATIONS.
Replacing the Ink Tanks
Replace the printer Ink Tanks when the ink runs out.
1. Open the Printer Toolbox. Go to the
Start Menu, then open the “Toolbox”.
You will see System Status information
in the upper left corner of the User
Interface window. Note that some or
all of the “CKMYK” boxes may be
low or empty.
2. Click “Replace Ink Tanks”. This disconnects Printer communication with the Ink Tanks and
allows safe installation and replacement. Once the “Confirm” screen displays, it is safe to remove
the Ink Tanks. IMPORTANT: DO NOT press “Continue” until after you have removed and
replaced the Ink Tank(s) and closed the Ink Tank Latches.
3. Open the Ink Tank Door (hinged at
bottom). Open the three Latches [A] and
pull the Ink Tank(s) from the unit.
4. Remove the new Ink Tank(s) from
packaging.
5. Insert the new Ink Tanks (labels up) into their
appropriate color slots [B]. Close the three Ink
Tank Latches.
INSTALLATION TIP: Make sure the Ink
Tanks seat properly. Insert the Ink Tank into
the appropriate Ink Station, then pull the Ink
Tank back about an inch and push forward
firmly to insure that the Ink Nozzles
penetrate the seals on the Ink Tanks.
To Next Page
Loading...
Need help?
General
