APPENDICES
186
3. Open the Top Cover.
4. Carefully remove the Printhead.
Place the printhead into the orange clip it originally
came in; for safe storage.
5. Open the Ink Tank Door (hinged at bottom).
6. Remove the Exit Roller Cover by removing the four
(4) screws.
REMOVE THE SERVICE STATION
1. Using the M Series Toolbox, Eject the
Service Station.
Press the Eject Service Station button
located in the User Interface window.
2. Once the printer has ejected the Service
Station; Power-down the printer using
the ON/OFF button. Then Switch the
Main Power Switch Off.
3. Carefully slide the Service Station out
of the Service Station Slot.
CAUTION: The Ribbon Cable is still connected to the Service Station. Do not pull the
Station too far out or you will damage the cable or connections.
WHENEVER POWERING DOWN UNIT, ALWAYS:
1. PRESS THE POWER BUTTON ON THE
CONTROL PANEL.
2. WAIT FOR THE PRINTER TO STOP
PROCESSING.
3. THEN PRESS THE MAIN POWER SWITCH
ON THE REAR PANEL.
To Next Page
Loading...
Need help?
General
