SECTION 6
MAINTENANCE
180
4. [1] Slide the Service Station into the Service Station
port until it touches the bar. Align with tracks along
sides and Guide on Service Station dock floor.
[2] Look down through the Top Cover to make sure
Service Station is aligned with the bar.
IMPORTANT! Service Station must be perfectly
aligned with bar to prevent misalignment and
operating problems.
5. GENTLY push the Service Station while
turning the large Gear on right side of Print
Engine clockwise. Gear should engage
gear on Service Station Roller and pull it
in. Once the Service Station starts moving,
stop turning the gear.
To Next Page
Loading...
Need help?
General
