option. (This changes the powered state of
the wired test port.)
Test PoE before Link: By default, an AutoTest
Wired Profile performs the Link test before the
PoE test can complete. Enable this setting to
make your Product complete the PoE test before
the Link test. Enabling this setting forces PoE
negotiation to be completed before establishing
link, improving compatibility with some
switches.
Charge Battery via PoE: (Available if supported
by tester hardware.) This setting is enabled by
default. If you do not want your Product unit to
charge when connected to a switch with PoE,
tap the toggle button to disable. An AutoTest
Wired Profile must run and detect PoE avail-
ability before the unit can use it for charging.
See also PoE Charging.
Receive Only: Enabling this setting prevents the
Product from transmitting packets on the Wired
Test Port. You can also use the Stop After
function in Wired AutoTest Profile Settings to
hide the AutoTest cards that require transmit
capability. Set the AutoTest Stop After setting to
General Settings and Tools
103
To Next Page
Loading...
Need help?
General
