Using VNC
Remotely access the EtherScope nXG Controlled
Edition using a peer-to-peer VNC client installed
on a PC or other machine.
See General Settings > VNC to enable and
configure VNC connections.
To connect to Product using a VNC client:
1. Get the IP address of a connected port
(preferably a management port) by swiping
down from the Status Bar at the top of the
screen to view the notification panel.
2. Provide the wired or Wi-Fi Test or Man-
agement Port's IP address to your chosen
VNC client application.
3. Connect using your VNC client.
4. If needed, enter the password that is set in
the VNC settings.
Using Link-Live Remote
The Link-Live Remote feature uses end-to-end
encryption, allowing secure remote control of
your Product.
Software Management
135
To Next Page
Loading...
