Charging and Power
Your EtherScope nXG Controlled Edition includes
a USB-C 15V/3A power adapter.
WCAUTION: Only the NetAlly-supplied power
adapter is supported.
To begin charging the internal lithium-ion
battery, plug the included power adapter into an
AC outlet and the USB-C charging port on the
left side of the unit. The Power button turns red
when the unit is in charging mode and turns off
at full charge. Refer to the Specifications for
battery run duration and charge times.
PoE Charging
Power over Ethernet (PoE) can provide
alternative power to your unit's battery. (Test
units that include the Charge Battery via PoE
setting in General Settings, support PoE.)
l
Negotiated PoE class levels 4-8 (≥ 25.5 W)
provide enough power to run the test unit
indefinitely and to charge the battery.
Introduction
29