l
Negotiated PoE class levels 0-3 (≤ 15.4 W)
provide some power to extend battery run
time but not enough to charge the battery.
Use the following steps to enable PoEcharging:
1. Connect the top RJ-45 port on the unit to a
network switch with PoE or to a PoE
injector.
2. Make sure the unit is powered on or in
display sleep mode.
3. If your test unit displays the Charge Battery
via PoE setting in General Settings, tap the
setting to enable PoEcharging.
4. Detect the PoE availability by running an
AutoTest Wired Profile with a PoE test that
passes. (The PoE Test must be enabled and
configured with a Powered Device Class
that is supported by your switch or PoE
Injector.) See Wired Profile Settings and
Results.
NOTE: If the AutoTest app is not currently
open, the last Wired Profile in the profile list
runs automatically when you power on the
Introduction
30
To Next Page
Loading...
Need help?
General
