EasyManuals Logo

netAlly ETHERSCOPE nXG User Manual

netAlly ETHERSCOPE nXG
820 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #104 background imageLoading...
Page #104 background image
Switch. Otherwise, when Receive Only is
enabled, the Wired DHCP/Static IP test shows a
Result Code of "Interface is configured to only
receive packets," and the subsequent tests do
not run.
User-Defined MAC: This setting affects the Wired
Test Port only. Tap the toggle switch to enable a
user-defined MAC address. When enabled, an
additional User-Defined MAC field appears
under the toggle setting. Tap the lower field to
enter your desired MAC address for the Product.
When a User-Defined MAC is enabled, (User-
defined) appears next to the MAC address on the
About screen and on relevant test result screens.
NOTE:This definition can be overridden by a
profile-based user-defined MAC. See " Wired
Connection Settings" on page252 for more
information.
Management
These settings affect management-related
functions on the Product, including remote
access.
General Settings and Tools
104

Table of Contents

Other manuals for netAlly ETHERSCOPE nXG

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the netAlly ETHERSCOPE nXG and is the answer not in the manual?

netAlly ETHERSCOPE nXG Specifications

General IconGeneral
BrandnetAlly
ModelETHERSCOPE nXG
CategoryTest Equipment
LanguageEnglish

Related product manuals