netAlly ETHERSCOPE nXG User Manual

Product's internal file system.
1. Make the certificate file available on your
Product unit by saving it to a USB drive or
Micro SD card inserted into your unit or by
transferring to the file system using a USB-C
cable or email. (See Managing Files for help.)
2. To run an AutoTest Wi-Fi Profile using cer-
tificate authentication, set up the profile
with the following settings:
a. Authentication: WPA/WPA2/WPA3
Enterprise
b. Encryption: Auto
c. EAP Type: EAP TLS, PEAP TLS, or TTLS
EAP TLS
To run an AutoTest Wired Profile using
802.1X with certificate authentication, set up
the profile with the following 802.1X test
settings:
a. 802.1X: Enabled
b. EAP Type: EAP TLS, PEAP TLS, or TTLS
EAP TLS
AutoTest App and Profiles
300

netAlly ETHERSCOPE nXG Specifications

General

Wi-Fi	802.11 a/b/g/n/ac
Ethernet	10/100/1000 Mbps
Display	7-inch touchscreen
Connectivity	Wi-Fi, USB, Ethernet
Protocols Supported	TCP, UDP, IPv4, IPv6
Protocols	Ethernet, Wi-Fi, DHCP, DNS, HTTP
Measurement Capabilities	Throughput, packet loss, latency, jitter
Cable Test	Wiremap, length
Discovery	Network devices, VLANs
Network Performance Tests	Throughput, packet loss, latency, jitter
Power	AC adapter or battery
Management	Web interface
Power over Ethernet (PoE)	IEEE 802.3af/at
Operating Temperature	32°F to 122°F (0°C to 50°C)
Humidity	10% to 90% non-condensing