EasyManuals Logo

netAlly ETHERSCOPE nXG User Manual

netAlly ETHERSCOPE nXG
820 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #394 background imageLoading...
Page #394 background image
Device Name: Enter the IP address or DNS name
of the target.
IP Protocol Version: IPv4 is used by default. Tap
the field to enable IPv6 instead.
Interface:This setting determines the Product
port from which the port scan runs. Tap the field
to select the port. (See Selecting Ports for explan-
ations of the different ports.)
Number of Tests: Tap to select the number of
Ping or TCP connect tests you want to run. The
default setting of Continuous keeps running
tests until you tap the STOP button.
Protocol: Tap to select the Ping or TCPConnect
protocol for the test.
Some of the following settings depend on the
selected protocol.
Frame Size (bytes): This setting only appears if
the Ping Protocol is selected. It specifies the
total size of the payload and header the Product
sends. Tap a radio button to select a new size, or
enter a Custom Value from 64 to 1518 bytes.
To test the Maximum Transmission Unit (MTU)
along a route to a target, select the MTU frame
Ping/TCP Test App
394

Table of Contents

Other manuals for netAlly ETHERSCOPE nXG

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the netAlly ETHERSCOPE nXG and is the answer not in the manual?

netAlly ETHERSCOPE nXG Specifications

General IconGeneral
BrandnetAlly
ModelETHERSCOPE nXG
CategoryTest Equipment
LanguageEnglish

Related product manuals