EasyManuals Logo

netAlly ETHERSCOPE nXG User Manual

netAlly ETHERSCOPE nXG
820 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #697 background imageLoading...
Page #697 background image
NOTE: The UDP port number entered here
must match the port number used by your
Peer endpoint device.
Endpoint Type: Select Peer or Reflector
depending on the type of endpoint you are using
for the performance test.
Traffic Flow: This setting only appears when
Endpoint Type is set to Peer.
l
Select Upstream only or Downstream only
to test only the single traffic flow direction
specified.
l
Select Asymmetrical to test each direction
using a different Target Rate (set under
Bandwidth below). Asymmetrical is the
default traffic flow for a Peer endpoint.
l
Select Symmetrical to test both directions
using the same Target Rate.
Frame Size
Tap the Frame Size field to select a new single
frame size, the Frame Size Mix option, or to
enter a Custom Value. The default is 512 bytes.
Performance Test App
697

Table of Contents

Other manuals for netAlly ETHERSCOPE nXG

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the netAlly ETHERSCOPE nXG and is the answer not in the manual?

netAlly ETHERSCOPE nXG Specifications

General IconGeneral
BrandnetAlly
ModelETHERSCOPE nXG
CategoryTest Equipment
LanguageEnglish

Related product manuals