Tap each Threshold field to select or enter the
maximum value allowed. If a measured value
exceeds the threshold value, the test fails.
Frame Loss Threshold: The Frame Loss
Threshold is the percentage of frames that can
be lost before the test fails. The default is 0.3%.
Tap the field to select or enter a new threshold
or to disable grading based on frame loss
altogether.
Jitter Threshold: Jitter is a measure of the
variation in frame-to-frame latency in mil-
liseconds. The default threshold is 20 ms.
Latency Threshold: Latency is the amount of
time it takes for a packet to go from the source
to the endpoint and endpoint to source in mil-
liseconds. The default threshold is 100 ms.
Layer 2 Options
The Performance Test runs over the Wired Test
Port link established by an AutoTest Wired
Profile. Therefore, by default, the Performance
Test runs using the VLAN ID configured in the
settings of the Wired AutoTest Profile that
established the link.
Performance Test App
704
To Next Page
Loading...
Need help?
General
