VLAN ID is not enabled, the VLAN is set to the
value used for the Wired Test port.
Override VLAN Priority: Tap the toggle button to
enable. By default, the VLAN priority is set to
Best Effort (0). Use this setting to simulate a
traffic stream of a certain type. If Override VLAN
Priority is not enabled, the VLAN priority is set to
the value used for the Wired Test port.
VLAN Priority: This setting only appears if the
Override VLAN Priority setting above is Enabled.
Tap to select a VLAN Priority.
Validate Priority: Tap the toggle button to
enable the Product to validate the selected VLAN
priority. When the Validate Priority option is
enabled, Product checks the packets it receives
to ensure that the priority field has been
maintained from source to destination. If it has
been altered, packets are counted as lost and
included in the Frame Loss measurement.
Layer 3 Options
Layer 3 options are useful when testing QoS
(Quality of Service) on your network. You can
create up to four Services using different DSCP
Performance Test App
706