5. On the Reflector Screen, Configure the
Packet Type and Swap settings as required.
The default settings, Packet Type: MAC +
NetAlly and Swap: MAC + IP, are recom-
mended to avoid any undesired traffic on
your network.
6. Select Save to apply any changed settings.
7. Select Start (F2) to run the Reflector.
8. The IP address of the Reflector is displayed
at the top of the screen. Enter this address
on the Endpoint Device screen in the Ether-
Scope nXG Controlled Edition's Performance
test Services settings.
For additional details on the LinkRunner AT
Reflector feature, see the LinkRunner AT User
Manual, available online.
Performance Test App
715