netAlly ETHERSCOPE nXG User Manual

Back to Title and Contents
Once open, the application automatically
detects available network interfaces and
their link status.
4. Check the box next to Enable Reflection for
each network interface you want to use as a
Reflector Endpoint for your Performance
Test.
5. Leave the application window open on your
PC during Performance testing.
6. Enter IP addresses for the interfaces you
want to test against on the Endpoint Device
screen in the EtherScope nXG Controlled
Edition's Performance Test Services settings.
Refer to the Help in the NPT Reflector software
for additional information.
Performance Test App
717

netAlly ETHERSCOPE nXG Specifications

General

Wi-Fi	802.11 a/b/g/n/ac
Ethernet	10/100/1000 Mbps
Display	7-inch touchscreen
Connectivity	Wi-Fi, USB, Ethernet
Protocols Supported	TCP, UDP, IPv4, IPv6
Protocols	Ethernet, Wi-Fi, DHCP, DNS, HTTP
Measurement Capabilities	Throughput, packet loss, latency, jitter
Cable Test	Wiremap, length
Discovery	Network devices, VLANs
Network Performance Tests	Throughput, packet loss, latency, jitter
Power	AC adapter or battery
Management	Web interface
Power over Ethernet (PoE)	IEEE 802.3af/at
Operating Temperature	32°F to 122°F (0°C to 50°C)
Humidity	10% to 90% non-condensing