Address: IP address of the endpoint
Endpoint Type: Peer or Reflector
Status: Current status of the test, including any
error messages
Rerunning Tests from Detailed Results
You can rerun a Performance Test from the
detailed results screen by tapping Start at the
top of the screen. This repeats the Performance
Test only for the Service that you are viewing.
Throughput, Loss, Latency, and Jitter
Graphs
The graphs described in this section update
every 5 or 30 seconds for as long as the test is
running. The graphs save and display data for
the entire test duration, with a max duration of
24 hours.
Peer endpoints display separate Up and Down
graphs (as shown below) for Throughput,
Frames Lost, Latency, and Jitter, while Reflector
endpoints display one round trip measurement
for each.
Performance Test App
722
To Next Page
Loading...
Need help?
General
