netAlly ETHERSCOPE nXG

o
A NetAlly EtherScope nXG or LinkRunner
10G with the LANBERTapplication
running as the LANBERTLoopback.
(Either device can function as the
loopback relay and can collect data at
the endpoint of the test.) See "LANBERT
Settings" on page755 for instructions on
setting up the loopback settings.
NOTE: The Loopback mode is designed to
stop whenever the LANBERTapp is not
displayed on the screen. If you plan to
run a long test, make sure that the
loopback unit is plugged into its AC
power supply and that you have turned
off the sleep function (go to system
Settings, tap Display > Sleep > Never).
Run the Test
You can set up and start either the
LANBERTgenerator or the LANBERTloopback
unit first. This procedure starts with the
generator.
1. On the Tester unit, open the LANBERT
application.
LANBERT™ Test App
762