5 0 port A bit-5 at logic level 0 (LOW)
*5 1 port A bit-5 at logic level 1 (HIGH)
6 0 port A bit-6 at logic level 0 (LOW)
*6 1 port A bit-6 at logic level 1 (HIGH)
7 0 port A bit-7 at logic level 0 (LOW)
*7 1 port A bit-7 at logic level 1 (HIGH)
* default setting
RETURNS If the “?” sign takes the place of nn value, this command reports the current
setting in hexadecimal notation.
REL. COMMANDS BO - set DIO port direction
EXAMPLE BO? | read DIO port direction configuration
0H | controller returns a value of 0H (all ports are input)
BO 1H | configure DIO port A as output
SB 0FFH | set all port A DIO output HIGH
Section 3 – Remote Mode 3-127
To Next Page
Loading...
