Nordson ProBlue Flex - Mounting the 400;480 V Melter on the Transformer

ProBlue Flex 400/480 Volt Transformer
F-17
Part 1128350_02
E 2020 Nordson Corporation
Mounting the 400/480V Melter on the Transformer
CAUTION! Be sure that the transformer wire harnesses are not pinched
between the transformer and the melter.
1. Position the two side spacers retained from the transformer shipping
container on the installed transformer. Maintain the orientation of the
notches as shown in Figure F-13.
2. Carefully lower the melter onto the transformer.
1
2
3
4
Figure F-13 Mounting the melter to the transformer
1. ProBlue Flex melter 2. Side spacers (two) 3. Transformer 4. Routing of cables