OHAUS Explorer EX423N/E - Page 105

EXPLORER BALANCES EN-103
To delete a user, select the user you
want to delete and press Delete. Then
press Yes to confirm.
For Group selection, you can set up to 100 operators, 10 Supervisor I, 2 Supervisor II and
1 Admin who is by default in total. Please check the following table for the permission of
each role.
Admin can create, edit or delete Supervisor I, Operator and Supervisor II, while
Supervisor I can create, edit or delete Operator. Operator and Supervisor II cannot access
User management menu.
Settings and Application
Admin
Supervisor I
Operator
Supervisor II
User management
√
√
x
x
Password policy
√
x
x
x
User settings
√
√
√
x
Balance setup
√
√
x
x
Calibration setting
√
√
x
x
External calibration
√
√
√
x
Internal calibration
√
√
√
x
Date & Time
√
x
x
x
Application modes settings
√
√
x
x
Units
√
√
x
x
Device & Print settings
√
√
x
x
GLP
√
√
x
x
Balance name
√
x
x
x
library
√
√
x
x
System log
√
√
x
√
Diagnostic
√
√
x
x
Routine test
√
√
√
x
Factory rest
√
√
x
x
Edit Settings
(when library record is activated)
√
√
x
x
Edit Settings
√
√
√
x
Minimum Weight
√
√
x
x
5.4.2 Password Policy
To set when password will expire. There are three selections, 30 days, 60 days and 90 days.
This function can also be turned off.
5.4.3 Auto Standby (minutes)
To set the time period for the balance to enter standby mode if no screen activity for x minutes.
Default value = OFF (disabled). Range is 1 to 240 minutes.
Note: When the balance enters standby mode, the current user will be automatically logged out.
You need to log in the next time you use the balance.
w ww . . co m
information@itm.com1.800.561.8187