5.10.4 Handshake
Set the flow control method.
NONE = no handshaking
XON-XOFF = XON/XOFF handshaking
HARDWARE = hardware handshaking (COM1 menu only)
5.10.5 Alternate Command
Enter this sub-menu to set a different command character for the P (Print), T (Tare) or Z (Zero)
commands.
Note: The selected character can only be used for one command.
Alternate Print Command
Set the alternate command character for Print.
Settings of A to Z are available. The default setting is P, except T&Z.
Alternate Tare Command
Set the alternate command character for Tare.
Settings of A to Z are available. The default setting is T, except P&Z.
Alternate Zero Command
Set the alternate command character for Zero.
Settings of A to Z are available. The default setting is Z, except P&T.
Print Settings Menu:
Note: If LEGAL FOR TRADE is set to ON, the print Output-Stable setting is not reset.
5.10.6 Print Output
Print Stable Weight Only
Set the printing criteria.
OFF = values are printed immediately, regardless of stability.
ON = values are printed only when the stability criteria are met.
Print Numeric Value Only
Set the printing criteria.
OFF = All data values are printed
ON = Only numeric data values are printed
Print Options
Set the way to print.
Printer = Print the result through a printer.
PC = Transfer the result to a computer.
5.10.7 Auto Print
Set the automatic printing functionality.
OFF = disabled
ON STABLE = printing occurs each time the stability criteria are met.
INTERVAL = printing occurs at the defined time interval.
CONTINUOUS = printing occurs continuously.
When ON STABLE is selected, set the conditions for printing.
LOAD = Prints when the displayed load is stable.
LOAD ZERO = Prints when the displayed load or zero reading is stable.
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
