EXPLORER BALANCES EN-137
TABLE 9-1. SPECIFICATIONS
Repeatability (std. dev.)
(20g)
Repeatability (std. dev.)
(100g)
Verification interval, e
(EX…M.. model only)
Approval Class
(EX…M.. model only)
Span Calibration Points (g)
g, mg, ct, oz , ozt, dwt, Grain, mom, tical, msg, tical, tola, baht, Customer Units 1,
Customer Unit 2, Customer Unit 3
Weighing units*
(EX…M.. model)
Weighing, Parts Counting, Percent Weighing, Check Weighing, Dynamic Weighing,
Filling, Totalization, Formulation, Differential Weighing, Peak Hold, Density
Determination, Pipette Adjustment, Statistical Quality Control
Stabilization time (typical)
Sensitivity Temperature
Drift
Typical Operating Range
USP (u=0.10%,k=2)
Optimal Operating Range
USP (u=0.10%,k=2)
Full-Color VGA Graphic LCD
5.7 in / 14.5 cm (diagonal)
4-wire resistive touch screen
AC Adapter Input: 100-240 VAC 0.6A 50-60 Hz
AC Adapter Output: 12 VDC 1.5A
Terminal Housing
dimensions
(W x D x H)
195 x 155 x 68 mm
7.7 x 6.1 x 2.7 inch
Base Housing dimensions
(W x D x H)
230 x 260 x 350 mm
9.1 x 10.2 x 13.8 inch
Assembled dimensions
(W x D x H)
230 x 393 x 350 mm
9.1 x 15.5 x 13.8 inch
Shipping dimensions
(W x D x H)
632 x 467 x 640 mm
24.9 x 18.4 x 25.2 inch
Note 1: M = EC Type approved
Note 2: Default Calibration weights shown in Bold
Note 3: * Availability is dependent on region.
w ww . . co m
information@itm.com1.800.561.8187