45762101TH Rev.1
2-22
2. TROUBLESHOOTING PROCEDURES
No.
Category
PJL Status
Code
Error Warning Description
34 Error 30941 1
2
3
4
5
USB Memory disconnected.
Please see Help for details.
Close
Indicates that the USB
memory was extracted.
When a USB memory
is extracted all over
ScanToMemory
execution, the file saving
of image file is stopped.
35 Error - 1
2
3
4
5
USB Memory disconnected.
Close
Indicates that the
USB memory is
disconnected while
PrintFromUSBMemory is
running. Reading of the
image file is cancelled.
36 Error - 1
2
3
4
5
Cannot open the file.
Close
Notifies that the specified
file cannot be opened.
37 Error - 1
2
3
4
5
Cannot read the file.
Close
Notifies that processing
has failed, for instance,
because of a fault in the
equipment in which the
data was to be stored.
38 Error - 1
2
3
4
5
Access denied to PC.
Please check PC.
Close
Indicates that PC rejects
a PushScan request.
（
Select Close with the
cursor and
）
press [OK]
button, and the display
will return to ScanTo
standby screen.
(At present, screens to
return to after errors have
been reset vary from
function to function. It is
desirable to return to the
same screen.)
No.
Category
PJL Status
Code
Error Warning Description
39 Error 30938 1
2
3
4
5
Decode error occurred.
Please check image data.
Close
Indicates that an error has
occurred during analysis
of image data input to
the MFP from an external
source.
This appears when an
error has occurred during
analysis of TIFF or JPEG
data in A05: DirectPrint,
A07: InternetFAX,
E-mailPrint, or FaxToPrint
(saving sent/received
data) mode.
40 Error - 1
2
3
4
5
Communication Error
Close
Indicates that the fax
sending was failed.
The details of the fax
sending errors are not
displayed.
The message is shown
after the job was finished
by communication
error and it is kept until
pressing a OK key.
It is reset at new
transmission. (When
Country Code is
Germany, it is not applied
by DTS.)
41 Error - 1
2
3
4
5
Communication Error
Close
Indicates that the fax
receiving was failed.
The details of the fax
receiving errors are not
displayed.
The message is shown
after the job was finished
by communication
error and it is kept until
pressing a OK key.
It is reset at new
transmission. (When
Country Code is
Germany, it is not applied
by DTS.)
To Next Page
Loading...
