Chapter 7
7-39
Configurator Settings
• Names can be set using up to 32 characters.
■ Setting Methods
Set the connected device comments in the following tab pages.
• Motor name: General Tab Page of the Edit Device Parameters Window.
• Name of device connected to the output terminal (I/O comment): OUT Tab Page in the Edit
Device Parameters Window.
• Name of device connected to the input terminal (I/O comment): IN Tab Page in the Edit Device
Parameters Window.
● Setting the Motor Name
1.Click the General Tab in the Edit Device Parameters Window.
2.Set a user-defined name (such as the motor type or model) in the Motor Name field.
● Setting the I/O Device Names
1.Click the OUT Tab in the Edit Device Parameters Window.
2.Set a user-defined name (output device name) in the I/O Comment field.
3.Click the IN Ta b.
4.Set a user-defined name (input device name) in the I/O Comment field.
Note For details on the setting window, refer to Setting Methods under 7-2-6 Cumulative ON Time
Monitor.
■ Checking Methods
Check the set connected device comments in the following tab pages.
• Motor name: Motor Name field on the General Tab Page of the Monitor Device Window (or
Maintenance Information Window).
General Tab Page in
the Monitor Device
Window
To Next Page
Loading...
