Chapter 2
2-3
Example System Startup
2-1-2 System Configuration Example
The following diagram shows the operating procedure using a system configuration example.
The system configuration shown here uses Thin Cables.
The following diagram is simplified, so it does not include the separate I/O power supply that must be
provided to the Output Unit (or Expansion Output Unit).
DCN1-3C
T-branch Tap
Communications
power supply
DCN1-1C
T-branch Tap
DCN1-1C
T-branch Tap
Terminating Resistor
CS1W-DRM21(-V1)
DeviceNet Master Unit;
(Node 63)
S82K-05024 24 VDC
Power Supply
(100 VAC, 50 W)
DRT2-ID16 Remote
I/O Terminal;
16 transistor inputs;
(Node 01)
DRT2-OD16 Remote
I/O Terminal;
16 transistor outputs;
(Node 02)
3G3MV-A2001 SYSDRIVE Inverter
3G3MV-PDRT2 DeviceNet
Communications Unit
Occupies 2 input words (32 input bits)
+ 2 output words (32 output bits).
(Node 03)
DRT2-OD16 Remote I/O
Terminal
16 transistor outputs;
XWT-OD08 Remote I/O
Terminal Expansion Unit;
8 transistor outputs;
(Node 05)
To Next Page