Omron 3G3MV-PDRT2 - Wiring the Inverter; Wiring the Remote I;O Terminal

Chapter 2
2-9
Example System Startup
■ Wiring the Remote I/O Terminal
Connect the I/O power supply for I/O devices and the I/O signal lines to the Remote I/O Terminals.
Attach M3 crimp terminals to the power lines and I/O signal lines and then connect them to the termi-
nal block.
■ Wiring the Inverter
Connect the power supply (200 VAC) to the Inverter.
When required, connect an I/O power supply for I/O devices and the I/O signal lines to the Inverter.
Note Refer to the Inverter’s operation manual for details on wiring the terminal block.