6 Performing Measurement and Adjustment
6 - 38
Vision System FH/FHV/FZ5 Series User’s Manual (Z365)
6-6 Updating the Reference Position Data
for a Unit in the Measurement Flow
[Update Standard Position Tool]
This section describes the use of a table to set or change the reference position for more than one pro-
cessing unit that you specify in the measurement flow.
To open the Update Standard Position Tool, select [Update standard position tool] from the [Tool] menu.
You can specify the following processing items.
You can update the reference position for measurement items in the flow without the need to open the
settings dialog box for each item.
For example, you can easily update the reference position that is updated frequently in an alignment
application.
To update the reference position, display the image to use as the reference in advance.
When you click the [Measure ref.] button, the Controller measures the reference for all units that are
selected in the [Unit Setting] list and updates the reference position.
If you click the reference position in the window, or enter the coordinates as a numeric value, the refer-
ence positions for the selected units in the [Unit Setting] list are updated with this value.
Items That Can Be Updated with the Update Standard Position Tool
• Search
• Sensitive Search
• Shape Search II
• Shape Search III
• EC Circle Search
•ECM Search
• Ec Corner
• Ec Cross
• Edge Position
• Scan Edge Position
• Circular Scan Edge Position
• Intersection
• Gravity and Area
• Labeling
Operating Procedure for the Update Standard Position Tool
To Next Page
Loading...
